Fill spa until water level is either: • the water in a hot tub or spa should never exceed 40°c (104°f).
Skip step 3 and move forward to steps 4 and 5.
Hot tub start up instructions. Test it with frog® test strips to get hardness, total alkalinity, and ph in the ideal ranges. Remove the hot tub panel closest to the pump. Prolonged immersion in a hot tub or spa may be injurious to your health.
Dig an area at least 8 inches longer and wider than the spa itself, and 6 to 8 inches deeper than the planned elevation of the hot tub. See our helpful infographic on water balancing. Covers all jets completely plus an inch;
Once you have filled your spa with water, you will need to add your preferred sanitiser. This agent will help combat any suspended minerals still present in the water. Floor must be able to withstand.
Fill spa by placing hose inside filter standpipe. Ideally wait until the spa is above 20 degrees celsius so the chemicals will dissolve quicker. Clean the empty hot tub.
• the water in a hot tub or spa should never exceed 40°c (104°f). Set the temperature to your desired level (at least 95 degrees fahrenheit) and turn off the salt system by setting the output level to zero (recommended). Identify the “minimum safe water level” line near the top.
Efully consider the placement car our hot tub before installation.of y. When air is bled out, tighten the union, turn the breaker on and set the pump on high speed. See owners manual for specifics.
Water temperatures between 38°c (100°f) and 40°c are considered safe for a healthy adult. Hot tub start up instructions. Immediately after the bromides are added, i shock the spa with chlorine granules.
Once your spa is filled, the next step in the hot tub start up process is adding chemicals to your spa for the first time. Talling your cleverspains ® indoors. Install or clean the filter.
Drain and clean your hot tub and fill with fresh water. Alkalinity needs to be balanced before balancing ph. If you press the “temp” button any time during priming mode, it will exit that mode and begin standard mode.
Immediately after the bromides are added, i shock the spa with chlorine granules. If balanced, move to step 3 only. Suitable drainage is essential when.
Fill the site with 3 to 4 inches of crushed stone. Keep the spa cover open for a few hours after shocking, to allow gas to escape. Weight of the cleverspa ® + occupants.
Or touching the bottom of the pillows. Once the spa’s foot well is filled, add in a sequestering agent (consult the bottle for proper dosage). Immediately after the bromides are added, i shock the spa with chlorine granules.
Loosen the white pressure union on the top of the pump by hand or with a strap wrench. Intended to get you into your hot tub and enjoying it right away. After spa is full, start power.
Follow these 12 simple steps to start a hot tub like a pro. Lower water temperatures are recommended for young children and when hot tub or spa use exceeds 10 minutes. Once the spa is filled with water, turn the power on (see spa owner’s manual for specific instructions based on the voltage of your hot tub).